Crowns, Joints and Flashing in Studio City, CA
Book a Roof-Level Look in Studio City
Send your name, number and what you see on top of the chimney. Expect a call to set a Studio City day and say what the visit covers.
Studio City Roofs We Climb
On these streets the chimneys sit on ranch houses on the flats near the river, canyon homes south of Ventura Boulevard, and some older Craftsman houses. If your house is near one of the names below, it is on our Studio City run.
What a First Studio City Roof Visit Covers
A close look at the top of a tall stack: the crown, each face, and where the flashing meets a steep roof, all photographed and explained. Each card below opens the Studio City page for that service.
Chimney Sweep in Studio City
A sweep clears creosote and soot, and while we are up there we photograph the crown and top joints too. Booked in Van Nuys and across the San Fernando Valley.
Learn MoreChimney Inspection in Studio City
We start on the roof with the crown, joints and flashing, then work down the flue. Van Nuys inspections come with photos of every face and a plain account of the build.
Learn MoreChimney Repair in Studio City
Most leaks start at the crown, the top joints or the flashing. We find which one in Van Nuys, show you the photo, and repair that part with matched brick and mortar.
Learn MoreFireplace Inspection in Studio City
The firebox, damper and smoke chamber checked part by part in Van Nuys, with the masonry above them looked at on the same visit.
Learn MoreFireplace Repair in Studio City
Cracked firebrick, a warped damper or worn smoke shelf mortar, repaired in Van Nuys with the material each part was built from.
Learn MoreChimney Level 2 Inspection in Studio City
The camera inspection a home sale calls for in Van Nuys, plus roof photos of the crown and top courses so buyers see the outside of the stack too.
Learn MoreChimney Cap Installation in Studio City
A cap is only as solid as the crown it sits on. In Van Nuys we fit stainless caps with spark screens and fix the crown under them first.
Learn MoreChimney Flashing Repair in Studio City
Flashing pulled away from the brick is behind most leaks beside a chimney. We cut counter flashing into the joints in Van Nuys instead of leaning on caulk.
Learn MoreChimney Masonry Repair in Studio City
Open joints near the top go first. We rake them out and repoint Van Nuys chimneys with mortar matched to the brick, face by face.
Learn MoreChimney Rebuilds in Studio City
When the courses above the roofline have shifted or split, we take them down to sound brick and relay them in Van Nuys, matched to the stack below.
Learn MoreFireplace Cleaning in Studio City
Ash, soot and creosote cleared from the firebox, hearth and glass doors in Van Nuys, on wood-burning and gas fireplaces.
Learn MoreGas Fireplace Cleaning in Studio City
Burner, pilot, thermocouple, logs and glass cleaned on gas fireplaces in Van Nuys, with a carbon monoxide check before we leave.
Learn MoreGas Fireplace Repair in Studio City
A gas fireplace that will not light or stay lit usually has a failed thermocouple, valve or igniter. We trace which one in Van Nuys before replacing anything.
Learn MoreFireplace Remodel in Studio City
New surrounds, mantels and insert conversions in Van Nuys, built after we check that the firebox and flue behind them are sound.
Learn MoreFireplace Inserts in Studio City
Gas, wood and electric inserts fitted into existing masonry fireboxes in Van Nuys, with the liner and venting the unit calls for.
Learn MorePellet Stove Repair in Studio City
Augers, igniters, blowers and control boards diagnosed and repaired on pellet stoves in Van Nuys.
Learn MoreWood Stove Repair in Studio City
Baffles, firebrick, door gaskets and combustors repaired on wood stoves in Van Nuys, with the stovepipe checked on the same visit.
Learn MoreGas Logs in Studio City
Vented and ventless gas log sets for masonry fireplaces in Van Nuys, sized to the room with a shut-off on the gas line.
Learn MoreReading the Top of a Studio City Chimney
Many Studio City chimneys date from the 1940s through the 1960s, and on the canyon lots they rise tall above steep roofs. That height is where the trouble collects: the top courses take the most sun and wind, and flashing on a steep pitch is the first seal to let go. Hot afternoons dry the mortar on the sunny face faster than the shaded one, so the joints often open on one side only. We show you which side and repoint that face when the rest of the stack is sound.
The Crown
Tall stacks put the crown out of sight from the street, so cracks go unnoticed. We photograph it close so you can see its condition without climbing up.
Joints and Flashing
Joints usually open on the sunny face first. We repoint that face with matched mortar and leave the shaded faces as they are when they are sound.
Above the Roofline
Steep roofs make flashing the weak point. We reflash with counter flashing cut into the brick, and relay any loose courses above it.
Booked Alongside
Studio City roof visits often share a day with Sherman Oaks, Encino, Toluca Lake.
Before Any Repair
Tell us what you see on top of your Studio City chimney.
A cracked crown, a stain beside the stack, brick that looks out of line. That is enough for us to plan the roof visit, and we explain the build before we quote.